I'm seeing a new behavior of my PICkit 3 that I did not have before. I hope someone can point me to a direction, it seems that I either messed with some MPLAB-X configurations, or my PICkit 3 is simply broken.
Device:
PIC24FV16KM204 MPLAB-X: 1.90
During firmware development I usually could just program my device at any time after I made some changes to the firmware. I could also debug my project at any time. Now the PICkit 3 always returns the error message "Failed to program device" when the device is not empty. So after each Firmware change, I'm currently closing MPLAB-X, starting the IPE, erasing the device and finally restarting MPLAB-X. Then I can successfully program the controller without error message.
What I have checked so far:
The project properties / Config PICkit3 / Program Options have a default setting for erasing everything before a new programming.
My configuration bits in the firmware disable the write protections (FBS and FGS)
This is the output of the PICkit 3:
Code:
Connecting to MPLAB PICkit 3...
Firmware Suite Version.....01.29.08
Firmware type..............dsPIC33F/24F/24H
Target detected
Device ID Revision = 0
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0xbff
configuration memory
Programming...
Calibration memory
Address: 0 Expected Value: 0 Received Value: 0
Failed to program device
Any hints are greatly appreciated. Regards,